device manager shows in IDE controllers the HD
(after a check for new hardware).
disk drives then installs same (with a balloon tip on
sys tray confirming same).
explorer does not show it or disk management
either.
going back to device manager under Disks, it is
gone!
IDE shows a secondary, but you have to do a re-
scan, and so the loop begins again?!
stu
----- Original Message -----
From: "Detlev Dreyer"
Newsgroups: microsoft.public.windowsxp.general
Sent: Saturday, February 17, 2007 2:50 PM
Subject: Re: Missing HD D:
> Detlev Dreyer wrote:
>
>>> BIOS does, connections are good...?
>>
>> This does not mean that you're all set. Check with the device manager
>> and with the disk management as well. "Anymore" means that the drive
>> has been already formatted and that is has been recognized in the past,
>> most likely. Also not clear if this is an internal or external drive.
>
> Addendum: Assuming an internal drive since showing up in the BIOS. Next
> question is what (hardware) changes have been made prior to the problem.
>
> --
> d-d
"Detlev Dreyer" wrote in message
> Detlev Dreyer wrote:
>
>>> BIOS does, connections are good...?
>>
>> This does not mean that you're all set. Check with the device manager
>> and with the disk management as well. "Anymore" means that the drive
>> has been already formatted and that is has been recognized in the past,
>> most likely. Also not clear if this is an internal or external drive.
>
> Addendum: Assuming an internal drive since showing up in the BIOS. Next
> question is what (hardware) changes have been made prior to the problem.
>
> --
> d-d >> Stay informed about: Missing HD D: